Flexible DRL LED Night & Daytime Running Light Strip (No Disassembling Needed)

Used for car exterior decoration light: Angel Eye Light, Daytime Running Lights, Turn Signal Lights, Eyebrow Lights, Rear Window Lights, etc

In addition to its good-looking appearance, the installation of daytime running light strips can reduce the traffic accident rate by 12.4% and the death rate by 26.4%. This is legal and safe.

FEATURES

• Suitable for any car model
• Easy to install without disassembly the headlights
• Non-flammable fire retardant burn
• Silicone material with good seal, waterproof , energy saving, anti-corrosion.
• Daytime running light strips are different from high beam, NO GLARE.

Detail:

• Only 4mm thick, can be installed in the gap between the Headlights and the Engine Hood with adhesive tape, no drilling, no screwing and no disassembling needed.

• Lights are white when turn signal light is off, then the lights flow yellow when turn signal light is switched on.
• Handpicked SMD-3014 LEDs, no dead light and dark spots, brighter than the stock halogen headlight bulbs. It’s a good replacement light for car original headlight.
• Unlike old designs where the DRL and Turn Signal share the IC Controller, these lights have separate IC Controllers which guarantee stability.
• Faster on/off response time and vibration resistant

DIY

• Power off during your customizing installation
• Cut down the strip along the line.
• Make sure no debris gets in.
• Sealing the tube with insulated glue after cutting in short.

Installation:

Easy Installation, just require right connect to positive and negative side

• Red wire: Power Positive(+)
• Black wire: Power Negative(-)/Ground
• Yellow wire: Left or Right Turn Signal Positive(+)

Universal fit for all 12V/24V auto vehicle, commonly used for Car, SUV, Vans, Truck, RV, Motorcycle, Scooter, Trailer etc.

SPECIFICATIONS

• • Material: Soft Rubber Tube.
  • Input Voltage: 12V/24V